NEC Univerge sv8500 Manual page 432

23. Setting frequency of Ringer:
MC(SIP)> SET RINGFREQ P1
Frequency of Ringer setting succeeded. (frequency
is 20Hz.)
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
24. Setting default sender PAD value:
MC(SIP)> SET SENDPAD P1
Default Sender PAD setting succeeded.
The SENDPAD command assigns the value to decrease voice level in the sender (analog terminal to IP)
Note:
direction.
The total PAD value (Sender PAD + Fax Sender PAD) is limited to 20dB.
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
25. Setting signaling port number for SIP:
MC(SIP)> SET SIGNALING_PORT_NO P1
Signaling Port Number setting succeeded.
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
8LC Card [SCA-8LCA/SCA-8LCA-EMEA/SCA-8LCC/SCA-8LCC-EMEA]
VOL.2-179
P1: Select the Ringer Frequency [0/1]
0=20 Hz (default)
1=25 Hz
Result is shown.
P1: Enter the sender PAD value [-10 ~ 20 (dB)]
(default=0)
Result is shown.
P1: Enter the Port Number used for SP-PHI.
[1024-65535] (default=5060)
Result is shown.