NEC Univerge sv8500 Manual page 714

MAINTENANCE COMMAND FOR MCMG
The Maintenance Console uses the commands listed in.
COMMAND No. SUB COMMAND
1 DEFAULTROUTE
2 DHCP
3 DRSADDRESS
4 DRSTOS
SET
5 HC_TIMER
(both MC and
6 INTERFACE
MG sides)
7 IPADDRESS
8 STARTPORT
9 VLAN
10 WARNING_TONE
COMMAND No. SUB COMMAND
1 BURSTPATTERN
2 CODEC_COEF
3 DSP_ECFB
4 EC_TRAINING
5 FAXERRORDETECT
6 FAXRECVPAD
7 FAXSENDPAD
SET
8 MUSICTYPE
(MC side)
9 OPEN
10 PAD
11 PRERINGING
12 RINGFREQ
13 SENDPAD
14 SMOOTH_PAD
15 STUTTERDT
FUNCTION
Setting Default Gateway:
Setting DHCP:
Setting IP address and port number of DRS:
Setting ToS of DRS session:
Setting Health Check Receive Timer:
Setting the communication speed for LAN interface:
Setting IP Address and Net Mask:
Setting RTP Start Port:
Setting VLAN:
Setting the Warning Tone for LAN failure:
FUNCTION
Setting Burst Ringer Pattern:
Setting CODEC Coefficiency:
Setting DSP echo canceller for FAX communication
Setting Training feature mode of echo canceller:
Setting FAX enable timer:
Setting Fax receiver PAD value:
Setting Fax sender PAD value:
Setting Internal Music-on-Hold type:
Setting Open/Reverse mode:
Setting default receiver PAD value:
Setting Pre-Ringing:
Setting frequency of Ringer:
Setting default sender PAD value:
Setting DSP smooth PAD mode:
Setting Stutter Dial Tone:
VOL.2-461
MCMG Card [SCA-7COTA]
REMARKS
REMARKS