NEC Univerge sv8500 Manual page 719

SET COMMAND (both MC and MG sides)
1. Setting Default Gateway:
MC-MG> SET DEFAULTROUTE 150.10.1.254
Default Gateway setting succeeded.
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
2. Setting DHCP:
MC-MG> SET DHCP ENABLE
DHCP setting succeeded.
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
3. Setting IP address and port number of DRS:
MC-MG> SET DRSADDRESS
DRS Unit (1: Primary/2: Secondary/3: Tertiary/4: Fourth): 1
DRS IP Address: 150.10.1.100
DRS Port Number: 3456
DRS setting succeeded.
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
About IP address of DRS (Telephony Server), refer to "Registration Destination of IP Devices/Stations" in
Note 1:
INTRODUCTION of Installation Manual.
Line 1: Enter Default Gateway Address.
Line 2: Result is shown.
Line 1: Enter ENABLE or DISABLE after the command
name.
ENABLE=DHCP is valid (default)
DISABLE=DHCP is invalid
Line 2: Result is shown.
Line 1: -
Line 2: Select "1" in normal condition.
Line 3: Enter IP Address of DRS. Note 1
(e.g. 150.10.1.100)
Line 4: Enter Port Number of DRS (1024-65535,
default = 3456).
Line 5: Result is shown.
VOL.2-466
MCMG Card [SCA-7COTA]