NEC Univerge sv8500 Manual page 712

8.4 Operation and Maintenance
8.4.1 How to Use Maintenance Command
"DRS (Device Registration Server)" used in this section refers to the Telephony Server. The Telephony
Note:
Server acts as DRS for MCMG Card using Proprietary Protocol.
When MCMG reboots itself due to such as an occurrence of health check timeout while maintenance com-
Note:
mands are executed, it takes about five minutes to start rebooting.
On a serial connection client (e.g. HyperTerminal), start up the program and uses maintenance command. Enter
"usrConsole" after the OS prompt (->).
When the maintenance command is started, the following prompt is indicated on the screen:
MC-MG>_
An example of indication is shown below:
MG-ID: 00004c292930
Boot program version: SP3839 SH7751R CBOOT-1 PROG-A [01.00.00.00]
Main program version: SP3849 MCMG PROG-A [01.00.00.00]
H/W PKG information:
H/W PKG information:
DSP information:
DSP information:
Starting Boot program.......
--- Online program Initial start (Wait for a while.) ---
Attached TCP/IP interface to (null) unit 0
Attaching interface lo0... done
Adding 7931 symbols for standalone.
------//--------------------------------------------//---
Media Converter - Media Gateway (COT Interface)
*Firmware SP-3849
*Compiled on Jun 9 2005 14:04:38
---//--------------------------------------------//------
->
->
->
-> usrConsole
MC-MG(COT) Maintenance Command Version 1.00
MC-MG >
("machine name" + ">", usually)
CA-CC04 001
CA-CC05 001
DSP-K-AC48302ck [03.11.00.00]
DSP-P-AC48302ce6 [03.11.00.00]
( 01.00.00.00 )
VOL.2-459
2005.04.13
MCMG Card [SCA-7COTA]