NEC Univerge sv8500 Manual page 953

PRECEDENCE (0-7) [6]: 6
DELAY (0/1) [0]: 0
THROUGHPUT (0/1) [0]: 0
RELIABILITY (0/1) [0]: 0
COST (0/1) [0]: 0
Signaling QoS setting succeeded. (0xC0)
The result of data setting is shown in a 1-byte (hexadecimal) format in accordance with the setting dialog
Note:
followed by the prompt. The meaning of 1-byte data is shown below:
Prec.
• When Diffserv is selected in QoS setting type:
MG-COT(SIP)> SET SIGNALING_QOS
QOS (TOS/DIFFSERV) [TOS]: DIFFSERV
DHCP (0-63) [48]: 48
Signaling QoS setting succeeded. (0xC0)
The result of data setting is shown in a 1-byte (hexadecimal) format in accordance with the setting dialog
Note:
followed by the prompt. The meaning of 1-byte data in ToS field for Diffserv is shown below:
DSCP
The designated Signaling QoS cannot be applied when Proprietary Protocol mode. Assign the SP mode
Note:
before executing this Signaling QoS setting.
The value in [ ] shows the current setting. Press enter key to apply the current setting shown in [ ].
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
D T R C
Line 3:Precedence: 0-7 (low-high)
Line 4:Delay: 0/1=Normal (default)/
Line 5:Throughput: 0/1=Normal
Line 6:Reliability: 0/1=Normal
Line 7:Cost: 0/1=Normal (default)/Cost
Line 8: Result is shown.
Prec.=PRECEDENCE (3 bits)
D=Delay
T=Throughput
R=Reliability
C=Cost
Line 2: Select QoS setting type
Line 3: Enter the setting value directly
Line 4: Result is shown.
DSCP = Differentiated Service Code Point (6 bits)
VOL.2-700
MG-COT Card [SCA-6COTB]
(default=6)
Low Delay ON
(default)/High Throughput ON
(default)/High Reliability ON
Precedence ON
(default=TOS)
(default=48)