NEC Univerge sv8500 Manual page 1255

13.4.6 SAVE Command
1. SAVE Δ CONFIGDATA
This command is used to save the configuration data.
MG-PRI > SAVE CONFIGDATA
** Don't power off in progress **
Do you need save? [Y/N]: Y
Configuration data for NC has been saved.
Re-starting is required for making a setup
reflect!!
2. SAVE ΔTCS_ CONFIGDATA
This command is used to save the configuration data for Trunk.
MG-PRI > SAVE TCS_CONFIGDATA
** Don't power in progress **
Do you need save? [Y/N]: Y
Configuration data for TC has been saved.
Re-starting is required for making a setup
reflect!!
1) Determine that a change in configuration data is
reserved.
Y: The data is saved
N: The data is not saved
A command is executed, and the result is displayed.
1) Determine that a change in trunk configuration data is
reserved.
Y: The data is saved
N: The data is not saved
A command is executed, and the result is displayed.
VOL.2-1002
MG-PRI/PRA