NEC Univerge sv8500 Manual page 789

ALOCL: Assignment of Location ID Data (LDM)
Each IP terminal is allocated a Location ID to identify its location within the network on Network Address
basis. By using the Location ID, IP services such as Bandwidth Control and ToS Control are provided for
each IP terminal.
TYPE: Select "Network Address".
IP ADDRESS: Enter the IP Address. For the Telephony Server (IPPAD), assign "0.0.0.0".
MASK BIT: Enter the Mask Bit in the range of 1-31 except when IP Address 0.0.0.0 is determined. Mask
Bit=32 is automatically set when IP Address=0.0.0.0
NETWORK ADDRESS: Display only.
LOC-ID: Assign the Location ID in the range of 0-4095, associated with the IP Address. When IP Ad-
dress=0.0.0.0, LOC-ID=0 is automatically set (the value cannot be changed).
LOC-ID=0 is predetermined to the Location ID of the Telephony Server (i.e.IPPAD).
Note:
Setting Type of Signaling Packet Service: Click the check box to assign the ToS for signaling packet.
IP PRECEDENCE/DIFFSERV:
<When IP PRECEDENCE is selected>
Priority:
Low Delay:
Through Put:
Reliability:
MIN Cost:
<When DIFFSERV is selected>
Priority:
Default settings (IP PRECEDENCE, Priority=6, Low Delay=OFF, Throughput=OFF, Reliability=OFF,
Note:
Min Cost=OFF) is applied when the check box is not clicked.
AIVCL: Assignment of IP Service Voice Control Data (LDM)
A LOC-ID:Location ID of the self-location [0-4095]
B LOC-ID:Location ID of the destination location [0-4095]
Setting of Jitter Buffer: Click the check box to assign the Jitter Buffer data.
JB_MIN:
JB_MAX: Jitter Buffer maximum value [0-30 (
Default settings (JB_MIN=1 (10 ms), JB_MAX=30 (300 ms)) is applied when the check box is not clicked.
Note:
Setting of Type of Service (Voice Packet): Click the check box to assign the ToS data for voice packet.
IP Precedence/DiffServ: Select either of the radio buttons.
<When IP Precedence is selected>
Precedence:
Low Delay:
Through Put:
Reliability:
MIN Cost:
<When DiffServ is selected>
DSCP:
Specify the precedence in the range of 0-7 (low-high).
Place a checkmark to set Low Delay to ON.
Place a checkmark to set High Throughput to ON.
Place a checkmark to set High Reliability to ON.
Place a checkmark to set Cost Precedence to ON.
Specify the DiffServ Code Point in the range of 0-63.
Jitter Buffer minimum value [0-30 (
Specify the precedence in the range of 0-7 (low-high).
Place a checkmark to set Low Delay to ON.
Place a checkmark to set High Throughput to ON.
Place a checkmark to set High Reliability to ON.
Place a checkmark to set Cost Precedence to ON.
Specify the DiffServ Code Point in the range of 0-63.
VOL.2-536
MG-COT Card [SCA-6COTA/SCA-6COTC]
× 10 milliseconds)]
× 10 milliseconds)]