NEC Univerge sv8500 Manual page 1251

Δ
20. SHOW TCS_LOOPBACK
This command is used to display the loopback settings for TC.
MG-PRI > SHOW TCS_LOOPBACK
value is 0x0000
Local Loop Back
Line Loop Back
Payload Loop Back
Dch Make Busy
Dch Loop Back
Dch Self-test
21. SHOW Δ TCS_PADP1
This command is used to display the specified PAD register for voice quality tuning. The following is an
example in the case of displaying PAD1.
MG-PRI > SHOW TCS_PAD0
value is 0x0000
A-law/u-law Setting
PAD Selection
PAD Control
PAD Pattern No.
Data PAD Pattern No.
The current setting is displayed.
- Internal Loopback (0/1=Disable/Enable)
- Line Loopback (0/1=Disable/Enable)
:0
- Payload Loopback (0/1=Disable/Enable)
:0
- Dch Make-Busy (0/1=Disable/Enable)
:0
:0
- Dch Loopback0 (0: Fixed)
:0
- Dch Self-Test (0: Fixed)
:0
P1-Specify the register number to be displayed.
The current setting is displayed.
:0
- CODEC
:0
:0
0=MGC Control (PBX System Data)
:0
1=
:0
2=A-law
3=Convert from A-law to
4=Convert from
- PAD selection (0/1=Standard/Flexible)
- PAD Control
0=Receiving Control (MG-PRI/PRA
1=Sending Control (ISDN Network
2=Fixed to ARTD
3=Sending/Receiving Control
- PAD Pattern number (0-4)
- Data PAD Pattern Number
0=64K
1=56K
2=64K Inversion
3=48K
4=Sbit Inversion
- Flexible PAD #N-Recv (0-36)
- Flexible PAD #N-Send (0-36)
VOL.2-998
0-4=PAD Register Number
μ
-law
μ
μ
-law to A-law
MG-PRI/PRA
-law
→
ISDN Network)
→
MG-PRI/PRA)