NEC Univerge sv8500 Manual page 1229

Δ Δ
16. SET SIGQOS [P1]
This command is used to specify Quality of Service (QOS) such as IP Precedence and Differentiated Ser-
vice (DIFFSERV) for Signaling Session. To make this assignment effective, it is required to execute the
"SAVE" command and to restart before exiting the maintenance command.
COMMAND 1
MG-PRI > SET SIGQOS
QOS (TOS/DIFFSERV:TOS):TOS
PRECEDENCE (0-7:0):6
DELAY (0/1:0):0
THROUGHPUT (0/1:0):0
RELIABILITY(0/1:0):0
COST (0/1:0):0
Signaling QoS setting succeeded. (0xC0)
In order to make a setup reflect, re-starting
is required after saving a configuration file
by SAVE command.
COMMAND 2
MG-PRI > SET SIGQOS
QOS (TOS/DIFFSERV:TOS):DIFFSERV
DSCP(0-63:0):48
Signaling QoS setting succeeded. (0xC0)
In order to make a setup reflect, re-starting
is required after saving a configuration file
by SAVE command.
COMMAND 3
MG-PRI > SET SIGQOS TOS 0xC0
Signaling QoS setting succeeded. (0xC0)
In order to make a setup reflect, re-starting
is required after saving a configuration file
by SAVE command.
COMMAND 4
MG-PRI > SET SIGQOS DIFFSERV 48
Signaling QoS setting succeeded. (0xC0)
In order to make a setup reflect, re-starting
is required after saving a configuration file
by SAVE command.
COMMAND 5
MG-PRI > SET DRSQOS CLEAR
Signaling QoS clearing succeeded. (0x00)
In order to make a setup reflect, re-starting
is required after saving a configuration file
by SAVE command.
Δ
[P2]
VOL.2-976
P1-Specify a type of services
TOS: IP Precedence
DIFFSERV: Differentiated Service
CLEAR: Clear the data
P2-Specify a value
00-FF (In the case of TOS)
0-63 (In the case of DIFFSERV)
When P2 is omitted (TOS selection)
→ COMMAND 1
When P2 is omitted (DIFFSERV selection)
→ COMMAND 2
When TOS in P1 and the settings in P2 are specified
→ COMMAND 3
When DIFFSERV in P1 and the settings in P2 are
specified
→ COMMAND 4
When CLEAR is specified in P1
→ COMMAND 5
<COMMAND 1>
1) Specify precedence (Default: 5)
0-7 (low-high)
2) Select a type of delay (Default: 1)
0/1=Normal/Delay
3) Select a type of throughput (Default: 1)
0/1=Normal/High Throughput
4) Select a type of reliability (Default: 0)
0/1=Normal/High Reliability
5) Select a type of cost (Default: 0)
0/1=Normal/Cost Precedence
A command is executed, and the result is displayed.
<COMMAND 2>
1) Enter the change effective timer
0=invalid to change to FAX mode
1-5=possible to change to FAX mode within 1-5
2) Specify Diffserv Codepoint (DSCP)
0-63=DSCP
A command is executed, and the result is displayed.
<COMMAND 3-5>
A command is executed, and the result is displayed.
MG-PRI/PRA