NEC Univerge sv8500 Manual page 1240

Δ Δ
26. SET TCS_T1_1
This command is used to specify T1 Dch data. To make this assignment effective, it is required to execute
the "SAVE" command and to restart before exiting the maintenance command.
COMMAND 1
MG-PRI > SET TCS_T1_1
Dch Control
Dch Mode
Dch Signal Logic
Dch-1 Drop/Insert
Dch-2 Drop/Insert
Drop/Insert Mode
Data Transfer Speed
Drop/Insert Time Slot( 0-23:23 ): 23
Dch Signaling Set
set value is 0x90B8
setting complete.
In order to make a setup reflect, re-starting
is required after saving a configuration file
by SAVE command.
COMMAND 2
MG-PRI > SET TCS_T1_1 90B8
set value is 0x90B8
setting complete.
In order to make a setup reflect, re-starting
is required after saving a configuration file
by SAVE command.
[P1]
( 0/1:1 ): 1
( 0/1:0 ): 0
( 0/1:0 ): 0
( 0/1:1 ): 1
( 0/1:0 ): 0
( 0/1:0 ): 0
( 0-2:0 ): 0
( 0/1:0): 0
VOL.2-987
P1-Specify a set value
0000-FFFF= Set value (default value: 90B8)
When P1 is omitted→COMMAND 1
When P1 is specified→COMMAND 2
<COMMAND 1>
1) Enable/Disable Dch Control
0/1=Disable/Enable (default)
2) Specify Dch Mode
0=User (default)
1=Network
Check connectivity for network in advance if you
will use Network mode.
3) Specify Dch Signal Logic
0=Positive Logic (default)
1=Negative Logic
4) Enable/Disable Dch-1
0/1=Disable/Enable (default)
5) Enable/Disable Dch-2
0 (fixed)
6) Drop/Insert Mode
0=Fixed value (default)
1=Set value
7) Specify Data Transfer Speed
0=64K (default)
1=56K
2=48K
8) Specify the number of Time Slot
0-23=Time Slot Number (default value: 23)
9) Specify Dch signaling set
0 (fixed)
A command is executed, and the result is displayed.
<COMMAND 2>
A command is executed, and the result is displayed.
MG-PRI/PRA