NEC Univerge sv8500 Manual page 751

SETUP COMMAND
To assign the data related to IP address simply:
• When DHCP option is used (to get DRS address):
MC-MG> setup
MG-ID = 00:30:13:16:ae:fa
Use DHCP?
Input [Y(Yes)/N(No)/Q(Quit)]:y
Use DHCP option? (Get DRS address)
Input [Y(Yes)/N(No)/Q(Quit)]:y
--------------------------------------
MG-ID = 00:30:13:16:ae:fa
DHCP = ENABLE
--------------------------------------
Input [Y(OK)/N(Change)/Q(Quit)]:y
• When DHCP option is not used
MC-MG> setup
MG-ID = 00:30:13:16:ae:fa
Use DHCP?
Input [Y(Yes)/N(No)/Q(Quit)]:y
Use DHCP option? (Get DRS address)
Input [Y(Yes)/N(No)/Q(Quit)]:n
DRS1 ADDRESS (XXX.XXX.XXX.XXX):1.1.1.1
--------------------------------------
MG-ID = 00:30:13:16:ae:fa
DHCP = ENABLE
DRS1 ADDRESS = 1.1.1.1
--------------------------------------
Input [Y(OK)/N(Change)/Q(Quit)]:y
About IP address of DRS (Telephony Server), refer to "Registration Destination of IP Devices/Stations" in
Note 1:
INTRODUCTION of Installation Manual.
MAC address is displayed.
Enter "y."
Enter "y."
Setting result is displayed.
Enter "y" when the assigned data is correct.
:
MAC address is displayed.
Enter "y."
Enter "n."
Enter the IP address of DRS.
Setting result is displayed.
Enter "y" when the assigned data is correct.
VOL.2-498
MCMG Card [SCA-7COTA]
Note 1