NEC Univerge sv8500 Manual page 1232

Δ
20. SET TCS_COMMON1
This command is used to specify common data 1 for T1/E1. When not specify an attribute on the interactive
setting, the original setting keeps being used. To make this assignment effective, it is required to execute
the "SAVE" command and to restart before exiting the maintenance command.
COMMAND 1
MG-PRI > SET TCS_COMMON1
Remote Alarm Sending ( 0/1:0 ): 0
Signal All 1
Idle Code Sending
Dch Back-up
Layer 1 Alarm Sending( 0/1:0 ): 0
Haul Mode
EC NLP Control
EC NLP Mode
EC 2100Hz bypass
Music Int/Ext
Music No.
Clock Mode
Layer1 Alarm Display
set value is 0x0215
setting complete.
In order to make a setup reflect, re-starting
is required after saving a configuration file
by SAVE command.
COMMAND 2
MG-PRI > SET TCS_COMMON1 0215
set value is 0x0215
setting complete.
In order to make a setup reflect, re-starting
is required after saving a configuration file
by SAVE command.
Default of "Music No" is "0 = Fur Elise" when the program version is SW423 2B or earlier.
Note:
Δ
[P1]
( 0/1:0 ): 0
( 0/1:0 ): 0
( 0/1:0 ): 0
( 0/1:0 ): 0
( 0/1:1 ): 1
( 0/1:0 ): 0
( 0/1:0 ): 0
( 0/1:0 ): 0
( 0-12:5 ): 5
(0/1:0):0
(0/1:1):1
P1-Specify a set value
0000-FFFF= Set value (default value: 0201)
When P1 is omitted→COMMAND 1
When P1 is specified→COMMAND 2
<COMMAND 1>
1) Disable/Enable Remote Alarm Sending
0/1=Enable(default)/Disable
2) Disable/Enable Signal All
0/1=Disable(default)/Enable
3) Disable/Enable Idle Code Sending
0/1=Disable(default)/Enable
4) Disable/Enable Dch Back-up
0/1=Disable(default)/Enable
5) Disable/Enable Layer 1 Alarm Sending
0/1=Enable(default)/Disable
6) Disable/Enable Haul Mode
0=Short (default)
1=Long
7) Disable/Enable EC NLP Control
0/1=Disable/Enable (default)
8) Specify EC NLP Mode
0=Background Noise (default)
1=Fixed Level
9) Disable/Enable EC 2100Hz Detect
0/1=Disable(default)/Enable
10) Select Music Source
0=Internal (default)
1=External
11) Specify Music No.
0=Fur Elise
1=Maiden's prayer
5=Minuet (default)
12) Specify clock mode
0=Secondary (default)
1=Primary
13) Disable/Enable Layer 1 Alarm LED display
0/1=Enable/Disable (default)
A command is executed, and the result is displayed.
<COMMAND 2>
A command is executed, and the result is displayed.
VOL.2-979
MG-PRI/PRA