NEC Univerge sv8500 Manual page 763

Trunk Line Appearance-D
Connecting an analog C.O. trunk and a virtual line one-to-one, this feature allows DtermIP user to directly
access C.O. line of MG-COT by pressing corresponding Line key on DtermIP station, without dialing ac-
cess code. DtermIP station can also answer incoming calls from C.O. line by pressing the Line key.
FRONT
MG0
MG1
MG0 MG2 MG4
100M LINK
ON
PWR ALM LINE
MG1 MG3 MG5
Ether OPERATION
Follow the service conditions below to use this feature by MG-COT:
(a) System data assignment for Trunk Answer from Any Station (TAS) is required for this feature, but
the TAS service is not activated.
(b) Whether the Trunk Answer from Any Station (TAS) feature is available or not is determined by the
Service Feature Restriction Class (SFC: 34) setting to each station.
(c) When Trunk Line Appearance-D station does not answer the incoming call and Call Forwarding-
Don't Answer is activated, the LCD on the DtermIP does not display to inform the execution of call
forwarding.
(d) Analog C.O. line corresponding to PB signal is only applicable.
(e) DtermIP stations must assign a My Line on Line/Feature key beforehand.
(f) All the virtual lines of C.O. trunk, excepting My Line, can be assigned as Trunk Line Appearance-D
lines on one DtermIP station. (e.g. On 16-button type of DtermIP station, a maximum of 15 lines can
be accommodated as Trunk Line Appearance-D. The remaining one line is the My Line.)
(g) Up to 128 of C.O. lines can be accommodated as Trunk Line Appearance-D per system.
(h) Distinctive Ringing is not activated when incoming call terminates.
MG-COT
MG2 MG4 PFT
MG3 MG5
CONSOLE
MUSIC
RESET
MG6
Route Name: COT-3
Route Name: COT-2
Route Name: COT-1
VOL.2-510
MG-COT Card [SCA-6COTA/SCA-6COTC]
PSTN
DtermIP
Analog
Telephone
Exit Help
Line/
Feature Key
6 4 10
2
1 3
Recall Feature
ABC DEF
Directory
1 11
9
4 5 6
Conf Mic
GHI JKL MNO
Message
2
7 8 9
Redial
PQRS WXYZ
TUV
3
0 Answer
#
OPER
7
5 8
Speaker
Hold Transfer