NEC Univerge sv8500 Manual page 1111

<Command List for SP-3826 BRI MG SIP BSC PROG-A Issue 5.0 or later>
This maintenance command is available for SP-3826 BRI MG SIP BSC PROG-A Issue 5.0 or later. configura-
tion data can be registered on line without turning off and on the power or pressing RESET switch to start a boot
program.
Run terminal software (e.g. HyperTerminal) to start maintenance program. Maintenance command launches by
entering "usrConsole" following the OS prompt (
shown on the screen.
MG-BRI(SIP)>_
When "exit" is entered on OS prompt, setting screen may stop. In this case, press CTRL + C keys to
Note 1: •
return to prompt.
Key operation of CTRL + S keys on maintenance console may stop setting screen. In this case, press
•
CTRL + Q keys to return to prompt.
Maintenance Command consists of some components: Command, Sub-command, and Parameter. The values to
be assigned for each Parameter depend on the Maintenance Command, some of the Maintenance Commands do
not require any parameter. A space needs to be entered between Command, Sub-command, and Parameter.
An example screen setting IP address (123.201.18.45) and subnet mask (255.255.255.0) in the system data of
MG-BRI (SIP) is shown below:
MG-BRI(SIP)>set own_ipaddress 123.201.18.45 255.255.255.0
Command
The communication condition is as follows.
Note:
- Speed: 9600bps
- Data Length: 8bits
- Parity Bit: None
<Dialogue Format Command Entry?>
Some of the Sub-command for "SET" Command value needs to be assigned in hexadecimal. Parameter can
be omitted in this case. Setting value will be decided in hexadecimal when any value was assigned in dia-
logue format. Also, value can be entered directly by hexadecimal. Sample configuration is shown below.
MG-BRI(SIP)>SET SIGNALING_QOS
QOS[I(IP PRECEDENCE)/D(DIFFSERV):IP PRE-
CEDENCE]:i
PRECEDENCE(0-7: 6):6
). When the system is ready, the following prompt is
Note 1
Sub-Command Parameter #1
VOL.2-858
MG(BRI) [SCA-2BRIA/MG-2BRIA]
Parameter #2
I: When IP PRECEDENCE is selected
Precedence in IP network (0-7) (6: Default)