NEC Univerge sv8500 Manual page 1340

Input new Port Number: 5060
Is there the Host Name? [Y/N]: Y
Input new Host Name: SVR1.nec.com
Continue? [Y (continue)/N (exit)]: N
--- Ethernet Speed set ---
Current LAN Speed: auto
Change LAN Speed? [Y (change)/N (current)/Q(quit)]: Y
Input new Speed [1 (AUTO)/2 (100M)/3(10M)]: 2
Input new DUPLEX [F (full)/H (half)]: F
** Don't power off in progress **
Do you save the configuration data? [Y/N] :Y
Configuration data has been saved.
Re-starting is required for making a setup reflect!!
SP mode setting succeeded.
About IP address of SIP server (Telephony Server), refer to "Registration Destination of IP Devices/Sta-
Note 1:
tions" in INTRODUCTION of Installation Manual.
The following are examples that cannot be used in the MG(PRI) setting:
Note:
(Example1) Network address cannot be assigned as IP address of MG(PRI).
IP address:192.168.1.0
Subnet mask: 255.255.255.0
(Example2) Broadcast address cannot be assigned as IP address of MG(PRI).
IP address:192.168.1.255
Subnet mask: 255.255.255.0
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
VOL.2-1087
16) Specify a new port number.
17) Select the host name setting.
Y: Use the host name
N: Do not use the host name
18) Specify the host name of SIP
Server.
19) Select whether you continue to
set up the host name or not.
Y: Continue the SIP Server set-
ting
N: Exit the SIP Server setting
The current setting is displayed.
20) Select the LAN setting.
Y: Change the setting
N: Remain the current setting
Q: Exit the command
21) Select the LAN speed.
1: Auto Negotiation (Default)
2: 100Mbps
3: 10Mbps
22) Select the LAN mode.
F: Full Duplex mode
H: Half Duplex mode
* This is not displayed when Auto
Negotiation is selected.
23) Select whether you save the
configuration data or not.
Y: Save the configuration data
N: Do not save the configuration
data
Result is displayed.