NEC Univerge sv8500 Manual page 909

Payload Size:
• If payload type G.711 is specified to more than two priorities in PRI1 through PRI4, assign different pay-
Note:
load size to each priority.
When payload types G.723.1 (5.3K → 6.3K) and G.723.1 (6.3K → 5.3K) are to be assigned on the same
•
terminal, specify the same value to the payload size of both types.
•
It is not necessary to assign the payload type/size to the whole priorities. Specifying the first priority
only is allowed.
•
For available payload type/payload size, refer to Peripheral Equipment Description, Volume 1, Chapter
2, "3.1.1 Bandwidth Required for Voice Traffic."
Setting of PAD: Click the check box to assign the PAD data manually. If not checked, default value 0 is
KIND2: Specify the PAD value of Analog MC in the range of 0-3.
KIND3: Specify the PAD No. of IPPAD in the range of 0-15.
Setting of Echo Canceller: Click the check box to assign the Echo Canceller data, and select one of the ra-
When the same value is assigned to both "A LOC-ID" and "B LOC-ID" parameters, select either "A EC-
Note:
ON/B EC-ON" or "A EC-OFF/B EC-OFF".
MG-COT needs to be rebooted after station data is assigned to reflect change. Confirm that there is no con-
Note:
versation in progress when rebooting.
[4] Security Data Assignment
Assign authentication data for SIP Mode.
ASECL:
Assignment of Security Data (LDM)
Assign the One Time Password to be used for authentication procedure in MG (6COT) registration.
Select one of the payload size in the combo box according to the Payload Type.
•No data
•10 milliseconds
•20 milliseconds
•30 milliseconds
•40 milliseconds
•60 milliseconds
applied.
•No PAD control (determined by ASYD, SYS1, INDEX 4, bit5 (5 dB PAD))
•PAD OFF (0 dB)
•3 dB
•6 dB
PAD value is determined by this PAD No. (0-15) and the setting of SW10-6/7 on IPPAD
card. Refer to the Circuit Card Description for more details.
dio buttons.
•A EC-ON/B EC-ON
•A EC-ON/B EC-OFF
•A EC-OFF/B EC-ON
•A EC-OFF/B EC-OFF
VOL.2-656
MG-COT Card [SCA-6COTB]