•
When DHCP Server is Enabled
Assign the following network data on MG(BRI) side.
•
Ethernet Speed
•
Signaling Port Number
•
RTP Start Port Number
•
Signaling QOS
•
VLAN
1.
Ethernet Speed
--- Ethernet Speed set ---
Current LAN Speed: 100MBPS_FD
Change LAN Speed? [Y (change)/N (current)/Q(quit)]: y
Input new Speed [1 (AUTO)/2 (100M)/3(10M)]: 2
Input new DUPLEX [F (full)/H (half)]: f
DUPLEX setting is not displayed when Auto negotiation is selected.
Note:
Assign the proper speed adjusting the network devices (router, HUB) on the destination.
Note:
2.
Signaling Port Number
--- Signaling Port Number set ---
Current Signaling Port Number: 64000
Change Signaling Port Number? [Y(change)/N(current)/Q(quit)]: y
Input new Signaling Port Number (1024-65535): 65000
Specify the same port number assigned on SIP server (Telephony Server).
Note:
Current data setting is displayed.
Y: To change the displayed data
N: Not change
Q: Quit Standard mode
Select the transmission speed of LAN interface.
1: Auto negotiation (default)
2: 100 Mbps fixed mode
3: 10 Mbps fixed mode
Select the Duplex mode.
F: Full duplex mode
H: Half duplex mode
VOL.2-823
MG(BRI) [SCA-2BRIA/MG-2BRIA]
Current data setting is displayed.
Y: To change the displayed data
N: Not change
Q: Quit Standard mode
Enter the port number of PHI signaling.
Port number: 1024~65535
(default = 64000)