NEC Univerge sv8500 Manual page 1345

14.4.7 SET Command
1. SET Δ CALL_HOLD
This command is used to set call retention. By setting "ENABLE" by this command, if a network failure
occurred between the Telephony Server and MG(PRI), the call will be retained. However, re-registration
to the Telephony Server will not be executed. To make this assignment effective, it is required to execute
the "SAVE" command and to restart before exiting the maintenance command.
MG-PRI(SIP)>SET CALL_HOLD DISABLE
CALL HOLD setting succeeded.
2. SET Δ COS Δ P1 Δ P2
This command is used to modify Class of Service (COS). Using this command is available while VLAN is
working. Note that VLAN setting is required before this setting. To make this assignment effective, it is
required to execute the "SAVE" command and to restart before exiting the maintenance command.
MG-PRI(SIP)>SET COS 1 7
COS setting succeeded.
3. SET Δ DEFAULTROUTE
This command is used to specify IP address for Default Gateway. Note that default route be located at the
same segment with MG(PRI). To make this assignment effective, it is required to execute the "SAVE" com-
mand and to restart before exiting the maintenance command.
MG-PRI(SIP)>SET DEFAULTROUTE 10.10.10.255
Default Gateway setting succeeded.
4. SET Δ DHCP Δ P1
This command is used to enable/disable DHCP server. To make this assignment effective, it is required to
execute the "SAVE" command and to restart before exiting the maintenance command.
MG-PRI(SIP)>SET DHCP ENABLE
DHCP setting succeeded.
Δ P1
Δ P1
P1- Enter the following after the command name
Result is displayed.
VOL.2-1092
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
P1-ENABLE / DISABLE
ENABLE=CALL_HOLD is valid
DISABLE=CALL_HOLD is invalid
(default)
Result is displayed.
P1-VLAN ID
1-4094=VLAN_ID
P2-COS value
0-7=COS
Result is displayed.
P1-Specify Default Gateway address
e.g. 10.10.10.255
Result is displayed.
ENABLE=DHCP is valid (default)
DISABLE=DHCP is invalid