NEC Univerge sv8500 Manual page 386

5.3.4 Configuration Command Assignment
Assign the configuration data by command operation on maintenance console.
"SIP server" used in this section refers to the Telephony Server. The Telephony Server acts as SIP server
Note:
for 8LC Card using SIP.
The setting data here is an example. Assign the network data adjusting to your network configuration.
Note:
STEP 1: When the boot program is started, the initial display below is displayed on the screen.
DP OK [N]
MC-ID: xxxxxxxxxxxx
Starting Boot program.....
--- Online program Initial start (Wait for a while) ---
STEP 2: Following the boot program, main program launches and the initial display below is displayed on the
screen.
-----//------------------------------------//-----
Analog Media Converter
---//------------------------------------//-------
>>> RegistrationMode = 8MC(SIP)
[SP Mode] MC Initializing....
In factory default (system data is in initial setting), 8LC Card starts up with the setting of DHCP en-
abled. The display is shifted to OS prompt (->) when 8LC Card tries getting IP address from DHCP
server.
8LC Card [SCA-8LCA/SCA-8LCA-EMEA/SCA-8LCC/SCA-8LCC-EMEA]
*Firmware SP-3893(xx.xx.xx.xx)
*Compiled on xxx xx xxxx xx:xx:xx
VOL.2-133