NEC Univerge sv8500 Manual page 1337

Input the desired command, sub command and each required parameter after the prompt ("MG-PRI>" as an ex-
ample here) is indicated. Parameters vary depending on the specified command. When each data (command
name, sub command name, parameter) is specified correctly, the command executes the required data process-
ing, and then informs the processed result on the screen. When finishing this program, you may input "EXIT"
(or "exit") after a prompt.
While the maintenance command program is activated, it also provides help function for referring to avail-
Note:
able command and sub command. After a prompt is indicated, request to list up the target help by inputting
"?", "command name + ?", or "command name + sub command name + ?" after the prompt, and press
the Enter key.
The example below shows the screen when executing help function regarding "set" and "set ipaddress."
MG-PRI(SIP)>set
?
COS
DEFAULTROUTE
DHCP
:
:
MG-PRI(SIP)>set ipaddress ?
xxx.xxx.xxx.xxx IP Address
MG-PRI(SIP)>set ipaddress 10.41.204.180 ?
xxx.xxx.xxx.xxx Subnetmask
MG-PRI(SIP)>
Setting COS
Setting Default Gateway
Setting DHCP
VOL.2-1084
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]