NEC Univerge sv8500 Manual page 1106

If the firmware issue is SP-3826 BRI MG SIP BSC PROG-A Issue 5.0 or later, if network data required for
Note 3:
starting up MG(BRI) could not be acquired from DHCP and DNS server, MG(BRI) will start up by using
IP address of SIP server registered in the configuration data of MG(BRI).
Configuration data is required.
Note 4:
Custom Mode
Display changes as follows when Custom mode is selected on the main menu. Input the required command
and parameter following the displayed command prompt in Custom mode to modify the default configu-
ration data.
<Configuration data setting mode>
MG-BRI>
<Basic Command Entry>
Displays the prompt of command interface, then displays the Reply message by analyzing the character
entered by the user. Command and Sub-command is mandatory, but parameter varies depending on each
command. Example of command, sub-command and parameter is shown below.
Prompt Command
MG-BRI> set
<Dialogue Format Command Entry?>
Ordinary command executes one order at a line, but for some of the command, value needs to be entered
in dialogue format because some of the command cannot execute an order in a line. For example, some of
the Sub-command for "SET" Command value needs to be assigned in hexadecimal. Parameter can be omit-
ted in this case. Setting value will be decided in hexadecimal when any value was assigned in dialogue for-
mat. Also, value can be entered directly by hexadecimal. Sample configuration is shown below.
MG-BRI>set signaling_qos
QOS[I(IP PRECEDENCE)/D(DIFFSERV):I]:I
PRECEDENCE(0-7: 6):6
DELAY(0/1): 0
THROUGHPUT(0/1: 0):0
RELIABILITY(0/1: 0):0
Sub-command Parameter 1 (P1)
own_ipaddress 123.201.18.45
VOL.2-853
MG(BRI) [SCA-2BRIA/MG-2BRIA]
Parameter 2 (P2)
255.255.255.0
I: When IP PRECEDENCE is selected
Precedence in IP network (0-7) (6: Default)
Precedence of Low Delay in IP network
0: Not specified (Default)
1: Specified
Precedence of Throughput in IP network
0: Not specified (Default)
1: Specified
Precedence of Reliability in IP network
0: Not specified (Default)
1: Specified