NEC Univerge sv8500 Manual page 1225

Δ
10. SET EC_TRAINING
This command is used to enable/disable the Training Feature mode of Echo Canceller. Echo Canceller Fea-
ture is used to prevent initial Echo (ranging from 500 to 1ms) from occurring in the beginning of speech to
PBX. To make this assignment effective, it is required to execute the "SAVE" command and to restart be-
fore exiting the maintenance command.
MG-PRI > SET EC_TRAINING ON
EC Training feature setting succeeded.
In order to make a setup reflect, re-starting is
required after saving a configuration file by
SAVE command.
Δ
11. SET FAXERRORDETECT
This command is used to specify the available time to be switched to FAX mode. To make this assignment
effective, it is required to execute the "SAVE" command and to restart before exiting the maintenance com-
mand.
MG-PRI > SET FAXERRORDETECT 1
Change effective of FAX setting succeeded.
12. SET Δ INTERFACE
This command is used to specify the specifications of connection mode. To make this assignment effective,
it is required to execute the "SAVE" command and to restart before exiting the maintenance command.
MG-PRI > SET INTERFACE
SPEED(AUTO/100M/10M):100M
DUPLEX(FULL/HALF):HALF
Ethernet Speed setting succeeded.
In order to make a setup reflect, re-starting is
required after saving a configuration file by
SAVE command.
axDev0 is needed as P1 when the program version is SW-423 PRI MG PROGRAM-A or earlier.
Note:
Δ
P1
Δ
P1
VOL.2-972
P1-Specify the following:
ON=Training function is valid
OFF=Training function is invalid (default)
P1-Specify the available time to switch to FAX.
0=FAX switching is unavailable.
1-5=Available time to be switched to FAX (minutes)
OFF=Always-on FAX switching
1) Select a line speed
AUTO=Auto Negotiation (default)
100M=100M
10M=10M
2) Select a type of duplex (In the case of selecting
FULL and HALF)
FULL=Full duplex
HALF=Half duplex
MG-PRI/PRA