NEC Univerge sv8500 Manual page 1074

12.3.4 Configuration Command Assignment
Assign the configuration data by command operation on maintenance console.
"SIP server" used in this section refers to the Telephony Server. The Telephony Server acts as SIP server
Note:
for MG(BRI) using SIP.
The setting data here is an example. Assign the network data adjusting to your network configuration.
Note:
STEP 1: Boot Program starts by turning the power ON or pressing RESET button on the front panel.
STEP 2: Press ESC key when the starting boot program message shown below appears.
Starting MG-BRI boot program...
Main menu of boot mode is displayed and configuration command entry is available on the mainte-
nance console.
STEP 3: Enter "1" after [Input:] then press Enter key.
-<Boot mode>Main menu-
Configuration data.
Quit
Input: 1
STEP 4: Main menu of the configuration mode appears. Enter "1" after [Input:] then press Enter key to start
Standard mode.
-<Configuration mode>Main menu-
Standard
Custom
Quit
Input: 1
Configuration command has two modes; Standard mode and Custom mode. Use Standard mode when start-
Note:
ing up MG(BRI) for the first time to assign the basic data for connecting network. See
to Use Maintenance Command
STEP 5: Assign whether DHCP server and DNS server are used or not.
(1) DHCP server enable/disable setting
--- DHCP Interface set ---
Current DHCP Interface: DISABLE
Change DHCP Interface? [Y (change)/N (current)/Q (quit)]: y
Input new DHCP Interface [E (enable)/D (disable)]: e
(2) DNS server enable/disable setting
--- DNS Interface set ---
--- input: 1
--- [Q/q]
--- input: 1
--- input: 2
--- [Q/q]
for the detailed information of each command.
VOL.2-821
MG(BRI) [SCA-2BRIA/MG-2BRIA]
Section 12.4.5 How