•
When DHCP server is NOT used
Set the following data on MCMG.
•
IP address of MCMG (own address)
•
IP address of Default Gateway
•
IP address and port number of DRS
When the DHCP is set to "ENABLE", IP addresses assigned here cannot take effect. Be sure to assign
Note:
"SET DHCP DISABLE" before starting the IP address setting.
About IP address of DRS (Telephony Server), refer to "Registration Destination of IP Devices/Stations"
Note 1:
in INTRODUCTION of Installation Manual.
Use SET IPADDRESS command to set the data IP address and Subnet mask of MCMG.
MC-MG> SET IPADDRESS 192.168.0.11 255.255.255.0
IP Address setting succeeded.
Use SET DEFAULTROUTE command to set the IP address of default gateway.
MC-MG> SET DEFAULTROUTE 192.168.0.254
Default Gateway setting succeeded.
Use SET DRSADDRESS command to set the IP address and port number of DRS (Telephony Server).
MC-MG> SET DRSADDRESS
DRS Unit (1:Primary/2:Secondary/3:Tertiary/4:Fourth):1
DRS IP Address: 192.168.0.1
DRS Port Number: 3456
DRS setting succeeded.
MCMG [SCA-4LC2COTA/MG-4LC2COTA]
Note 1
VOL.2-350