NEC Univerge sv8500 Manual page 950

11. Setting Fax receiver PAD value
MG-COT > SET FAXRECVPAD_MG P1
Fax Receiver PAD setting succeeded.
The FAXRECVPAD_MG command assigns the value to decrease the Fax signal level in the receiver (PSTN
Note:
to IP) direction when the Fax signal is detected.
The total PAD value (Receiver PAD + Fax Receiver PAD) is limited to 20dB.
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
12. Setting Fax sender PAD value
MG-COT > SET FAXSENDPAD_MG P1
Fax Sender PAD setting succeeded.
The FAXSENDPAD_MG command assigns the value to decrease the Fax signal level in the sender (IP to
Note:
PSTN) direction when Fax signal is detected.
The total PAD value (Sender PAD + Fax Sender PAD) is limited to 20dB.
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
13. Setting Health Check Receive Timer
MG-COT > SET HC_TIMER P1
Health-Check Timer Timeout setting succeeded.
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
14. Setting I/C call abandon timer
MG-COT > SET IC_ABANDON_TIME P1
Line 1: Enter the Fax Receiver PAD
Line 2: Result is shown.
Line 1: Enter the Fax Sender PAD value
Line 2: Result is shown.
Line 1: Enter the time (second) in the
Line 2: Result is shown.
Line 1: Enter the Incoming call abandon
VOL.2-697
MG-COT Card [SCA-6COTB]
value in the range of 0-20 after
the command name (default=0).
in the range of 0-20 after the
command name (default=3).
range of 120-240 (at intervals of
30 seconds) (default=150).
timer (0-2).
0=6 seconds (default)
1=3 seconds
2=1 second