NEC Univerge sv8500 Manual page 1252

Δ
22. SHOW TCS_T1_P1
This command is used to display the specified T type settings for TC. The following is an example when
selecting 1 in T type.
MG-PRI > SHOW TCS_T1_1
value is 0xFD0C
Dch Control
Dch Mode
Dch Signal Logic
Dch-1 Drop/Insert
Dch-2 Drop/Insert
Drop/Insert Mode
Data Transfer Speed
Drop/Insert Time Slot
Dch Signaling Set
P1-Specify a type of T carrier.
1-3=T type
The current setting is displayed.
:1
:0
<T1_1>
:0
- Dch Control (0/1=Disable/Enable)
:1
- Dch Mode (0/1=User/Network)
:0
- Dch Signal Logic (0/1=Positive Logic/Negative Logic)
:0
- Dch-1 (0/1=Disable/Enable)
:0
- Dch-2 (0: Fixed)
:23
- Mode (0/1=Fixed value/Set value)
:0
- Data Transfer Speed (0=64K/1=56K/2=48K)
- Time Slot (0-23)
- Dch Signaling Set (0: Fixed)
<T1_2>
- Remote Alarm (0/1=Data Link, Fs bit/In Channel)
- Alarm Operation Mode (0/1=Enable/Disable)
- Alarm Release Timing (0/1=Short/Long)
- Alarm Detect/Release Type (0/1=Normal/AT&T)
- Line Signal(0/1=B8ZS/AMI ZCS)
- Multi Frame(0/1=24 Multi Frame/12 Multi Frame)
- Signaling in Channels (0: Fixed)
- Dch Mode (0/1=ITU-T/AT&T)
- Equalizer (0=0-40m/1=41-80m/2=81-121m/3=122-
161m/ 4=162m or more)
<T1_3>
4K Data Link(0/1=MOS/BOS)
- G.704 Mode(0/1=ITU-T G.704/JG.704)
- BOS/MOS Operation (refer to page 989)
- Signaling A Logic-Recovery (1: Fixed)
- Signaling Pattern Recovery (2: Fixed)
- Signaling A Logic Sending (1: Fixed)
- Signaling Pattern Sending (2: Fixed)
VOL.2-999
MG-PRI/PRA