NEC Univerge sv8500 Manual page 447

REBOOT COMMAND
To reboot the 8LC Card:
MC(SIP)> REBOOT
Do you need reboot? (Y/N): Y
The screen returns to the prompt of the configuration command (MC(SIP)>) if any error occurs after se-
Note:
lecting "Y".
EXIT COMMAND
To exit the configuration command:
[Normal occasion]
MC(SIP)> EXIT
Finished!
->
[When configuration data is changed]
MC(SIP)> EXIT
Configuration data was changed.
** Don't power off in progress **
Y: Save and Exit.
N: Exit without saving.
C: Cancel
(Y/N/C): Y
Configuration data has been saved.
Finished!
->
When the "exit" command is executed on the OS prompt (
Note:
press the CTRL + C keys simultaneously to display the OS prompt (
The screen returns to the prompt of the configuration command (MC(SIP)>) if any error occurs after se-
Note:
lecting "Y".
8LC Card [SCA-8LCA/SCA-8LCA-EMEA/SCA-8LCC/SCA-8LCC-EMEA]
Enter "Y" to reboot the 8LC Card.
Enter "Y" to save the changed configuration data.
VOL.2-194
−>
), key operation turns unaccepted. In this case,
−>
) again.