NEC Univerge sv8500 Manual page 1024

SAVE: Command to save the modified configuration
Sub-command
1 CONFIG
EXIT: Command to exit the configuration setting mode
Sub-command
1 -
REBOOT: Command to reboot the MG-BRI
Sub-command
1 -
What to enter next can be confirmed by entering ["?"] after the command. For example, to confirm what
Note:
to enter after the "SET" command will be ["SET (Command Name)" + "?"]. To confirm the parameter
after the Sub-command, it will be ["SET (Command Name)" + "OWN_IPADDRESS (Sub-command
Name) + "?"]. Help screen of "SET" command is shown below as an example.
MG-BRI>SET?
INTERFACE
DHCP
OWN_IPADDRESS
DEFAULT_GATEWAY
DRS_IPADDRESS
SIGNALING_QOS
:
:
This command is used to save the modified configuration data to the
Flash card.
This command is used to exit the MG-BRI. Save the latest configura-
tion using SAVE command and then exit from the MG-BRI setting.
Confirmation message appears when the configuration has not been
saved.
This command is used to reboot the MG-BRI.
Setting Ethernet Speed (Def.AUTO)
Setting DHCP interface (Def.ENABLE)
Setting IP Address & Subnetmask (Def.0.0.0.0/0.0.0.0)
Setting Default Gateway IP Address (Def.0.0.0.0)
Setting DRS IPAddress & port number(Def.0.0.0.0 / 3456)
Setting Signaling QOS (Def.IP Precedence[0xC0])
VOL.2-771
Function
Function
Function
:
:
MG-BRI