NEC Univerge sv8500 Manual page 411

5.4.5 How to Use Maintenance Command
"SIP server" used in this section refers to the Telephony Server. The Telephony Server acts as SIP server
Note:
for 8LC Card using Proprietary Protocol.
When 8LC Card reboots itself due to such as an occurrence of health check timeout while maintenance
Note:
commands are executed, it takes about five minutes to start rebooting.
On a serial connection client (e.g. HyperTerminal), start up the program and use maintenance command. Enter
"usrConsole" after the OS prompt (->).
When the maintenance command is started, the following prompt is indicated on the screen:
MC(SIP)>_
An example of indication is shown below:
MC-ID: 00301caf2c1d
Boot program version
Main program version
H/W PKG information
H/W PKG information
DSP information
DSP information
Starting Boot program.......
--- Online program Initial start (Wait for a while) ---
Attached TCP/IP interface to dp unit 0
Attaching interface lo0... done
Adding 10292 symbols for standalone.
8LC Card [SCA-8LCA/SCA-8LCA-EMEA/SCA-8LCC/SCA-8LCC-EMEA]
("machine name" + ">", usually)
:SP3839 SH7751R CBOOT-1 PROG-A [03.00.00.00]
:SP3893 8MC PROG-A [01.00.00.00]
:CA-CC12 3A
:PZ-CC171 2A
:DSP-K-AC49kernel [01.07.06.00]
:DSP-P-AC490012ae3 [01.07.07.02]
VOL.2-158