8.3.4
Configuration Command Assignment
Assign the configuration data by command operation on maintenance console.
"DRS (Device Registration Server)" used in this section refers to the Telephony Server. The Telephony
Note:
Server acts as DRS for MCMG Card using Proprietary Protocol.
The setting data here is an example. Assign the network data according to your network configuration.
Note:
STEP 1: When the boot program is started, the initial display below is displayed on the screen.
MCMG-ID: xxxxxx
Starting Boot program......
--- Online program Initial start (Wait for a while.) ---
:
:
:
->
->
->
STEP 2: Type "usrConsole" at the indicated OS prompt and press the ENTER key.
->
->
->usrConsole
STEP 3: MCMG command prompt appears as follows.
->
->usrConsole
MC-MG(COT) Maintenance command Version 1.00 2005.4.13
MC-MG>
STEP 4: Set the network data depending on your LAN environment.
There are two ways to set the network data; DHCP server is used or not used.
<When DHCP server is used>
Set the following data on DHCP server.
•
IP address of Default Gateway
VOL.2-449
MCMG Card [SCA-7COTA]