NEC Univerge sv8500 Manual page 828

• When DHCP server is not used:
MG-COT > setup tp
MG-ID = xx:xx:xx:xx:xx:xx
Use DHCP?
Input (Y:Yes / N:No / Q:Quit) : n
OWN IP ADDRESS [0.0.0.0] : 1.1.1.10
SUBNET MASK [255.255.255.255] : 255.255.255.0
DEFAULT GATEWAY [0.0.0.0] : 1.1.1.254
DRS1 ADDRESS [0.0.0.0] : 1.1.1.1
--------------------------------------------
MG-ID = xx:xx:xx:xx:xx:xx
DHCP = DISABLE
OWN IPADDRESS = 1.1.1.10
OWN SUBNETMASK = 255.255.255.0
DEFAULT ROUTE = 1.1.1.254
DRS1 ADDRESS = 1.1.1.1
--------------------------------------------
Input (Y:OK / N:Change / Q:Quit) : y
** Don't power off in progress **
Do you save the configuration data? (Y/N) : y
Configuration data has not been saved.
Re-starting is required for making a setup
reflect!!
TP mode setting succeeded.
The register mode will be changed to
TP mode after re-starting.
MG-COT >
The value in [ ] shows the current setting. Press enter key to apply the current setting shown in [ ].
Note 1:
About IP address of DRS (Telephony Server), refer to "Registration Destination of IP Devices/Stations" in
Note 2:
INTRODUCTION of Installation Manual.
MG-COT Card [SCA-6COTA/SCA-6COTC]
MAC Address is displayed.
Enter "n".
Enter the IP address of MG-COT Card.
Note 1
Enter the Subnet mask. Note 1
Enter the default gateway. Note 1
Enter the IP address of DRS
Note 1
Setting result is displayed.
Enter "y" when the assigned data is cor-
rect. Note 3, Note 4
Enter "y" when saved the configuration
data.
Result is shown.
VOL.2-575
,
Note 2