NEC Univerge sv8500 Manual page 1308

• When DHCP server is used
As DHCP server automatically assigns IP addresses to MG(PRI), Default Gateway, and the Telephony
Server, there is no need to assign these network data on MG(PRI) side. IP addresses listed below, however,
have to be prepared in DHCP server side.
• IP address of Default Gateway
• IP address and port number of SIP Server
* Check the number of IP addresses saved in DHCP server is sufficient to provide IP addresses for
MG(PRI)s anytime.
DHCP option setting is as follows.
Note 1:
Class: Global
Name: Not specified, but do not enter the same option name in duplicate
Data: IP address
Array: Checked
Code: 162
Refer to DHCP Server in Volume 1 of this manual for more information on DHCP option setting.
About IP address of SIP server (Telephony Server), refer to "Registration Destination of IP Devices/Sta-
Note 2:
tions" in INTRODUCTION of Installation Manual.
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
Note 1
Note
VOL.2-1055