NEC Univerge sv8500 Manual page 837

• When DHCP server is not used:
MG-COT
> setup
MG-ID = 00:30:13:16:ae:fa
Use DHCP?
Input [Y(Yes)/N(No)/Q(Quit)]:n
OWN IP ADDRESS (XXX.XXX.XXX.XXX):1.1.1.10
SUBNET MASK (XXX.XXX.XXX.XXX):255.255.255.0
DEFAULT GATEWAY (XXX.XXX.XXX.XXX):1.1.1.254
DRS1 ADDRESS (XXX.XXX.XXX.XXX):1.1.1.1
-------------------------------------------
MG-ID = 00:30:13:16:ae:fa
DHCP = DISABLE
OWN IPADDRESS 1.1.1.10
OWN SUBNETMASK 255.255.255.0
DEFAULT ROUTE 1.1.1.254
DRS1 ADDRESS 1.1.1.1
-------------------------------------------
-
Input [Y(OK)/N(Change)/Q(Quit)]:y
About IP address of DRS (Telephony Server), refer to "Registration Destination of IP Devices/Stations" in
Note 1:
INTRODUCTION of Installation Manual.
Follow the procedure below when changing the assigned data.
Note 2:
<e.g. When DHCP server is not used>
Input [Y(OK)/N(Change)/Q(Quit)]:n
Change list.
DHCP
OWN IPADDRESS
OWN SUBNET
DEFAULT ROUTE
DRS1 ADDRESS
Input [Q(Quit)]:1
--- input:1
--- input:2
--- input:3
--- input:4
--- input:5
VOL.2-584
MG-COT Card [SCA-6COTA/SCA-6COTC]
MAC address is displayed.
Enter "n".
Enter the IP address of MG-COT Card.
Enter the Subnet mask.
Enter the default gateway.
Enter the IP address of DRS.
Setting result is displayed.
Enter "y" when the assigned data is correct.
,
Note 2 Note 3
Enter "n".
Data items to change are listed.
Enter the item number to be changed.
Note 1