NEC Univerge sv8500 Manual page 1367

14.4.8 SHOW Command
1. SHOW Δ CALL_HOLD
This command is used to display the current call hold settings.
MG-PRI(SIP)>SHOW CALL_HOLD
CALL HOLD is DISABLE
Δ
2. SHOW CONFIG
This command is used to display the current network settings.
MG-PRI(SIP)>SHOW CONFIG
[SYSTEM]
DEBUG_LEVEL=0
DHCP_BKUP=OFF
DHCP_SAVE=OFF
REGISTER_MODE=SP
[IP]
OWN_ADDR=10.41.1.100
SUBNET_MASK255.255.255.0
DEFAULT_GATEWAY=10.41.1.254
:
:
3. SHOW Δ DHCP
This command is used to display whether DHCP is enabled at current network.
MG-PRI(SIP)>SHOW DHCP
DHCP is ENABLE
4. SHOW Δ DNS_SW
This command is used to display whether DNS is enabled at current network.
MG-PRI(SIP)>SHOW DNS_SW
DNS interface : DISABLE
DNS IP address : 10.41.1.150
5. SHOW Δ DRSADDRESS
This command is used to display the status of DRS.
About IP address of DRS (Telephony Server), refer to "Registration Destination of IP Devices/Stations" in
Note:
INTRODUCTION of Installation Manual.
Δ [P1]
VOL.2-1114
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
The current setting is displayed.
The current setting is displayed.
The current setting is displayed.
The current setting is displayed.