NEC Univerge sv8500 Manual page 1283

To change the data for existing route (RT), initialize or reboot the trunk device such as circuit card, MG, or
Note:
VS-32.
• For ISDN Trunk Data
RT=20 (Virtual Speech Channel)
CDN 2 (ONSG) = 2
The other data should be "0" (default data).
To change the data for existing route (RT), initialize or reboot the trunk device such as circuit card, MG, or
Note:
VS-32.
INT (CDN65):
Note 1:
In the case of "SUB ADDRESS - ADDRESSING", assign "0". (Refer to SUB ADDRESS-ADDRESSING
Note 2:
[S-95] in Data Programming Manual - ISDN.)
In the case of "DID ADDRESSING", refer to DIRECT INWARD DIALING (DID) ADDRESSING [D-123]
in Data Programming Manual - ISDN.
4 (INSG) = 2
5 (TF) = 3
6 (TCL) = 1
7 (L/T) = 1
8 (RLP) = 2
10 (SMDR) = 1
15 (LSG) = 12
28 (ANS) = 1
30 (PAD) = 4
31 (OGRL) = 1
32 (ICRL) = 1
34 (GUARD) = 1
45 (A/D) = 1
50 (DPLY) = 1
60 (TC/EC) = 1
65 (INT) = Note 2
66 (DC) = Note 3
1 N-ISDN2
2 Australia
4 ITU (CCITT), ETSI (PRI)
5 AT&T (#4/#5 ESS)
6 ETSI (BRI)
7 NT DMS 100 / DMS 250
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
RT=10 (Virtual Signaling Channel)
CDN 2 (ONSG) = 2
4 (INSG)
6 (TCL)
7 (L/T)
8 (RLP)
15 (LSG)
28 (ANS)
30 (PAD)
65 (INT)
66 (DC)
VOL.2-1030
= 2
= 1
= 1
= 2
= 13
= 1
= 7
= Note 2
= Note 3