NEC Univerge sv8500 Manual page 1350

Δ
12. SET FAX_ECM
This command is used to enable/disable the FAX ECM. To make this assignment effective, it is required to
execute the "SAVE" command and to restart before exiting the maintenance command.
MG-PRI(SIP)>SET FAX_ECM
ECM (ON/OFF: OFF):OFF
Fax ecm setting succeeded.
13. SET Δ FAXERRORDETECT
This command is used to specify the available time to be switched to FAX mode. To make this assignment
effective, it is required to execute the "SAVE" command and to restart before exiting the maintenance com-
mand.
MG-PRI(SIP)>SET FAXERRORDETECT 1
FAX Enable Timer setting succeeded.
14. SET ΔHC_RCV_TIMERΔ
This command is used to specify a value recognized as timeout in receiving health check. To make this as-
signment effective, it is required to execute the "SAVE" command and to restart before exiting the main-
tenance command.
MG-PRI(SIP)>SET HC_RCV_TIMER 120
Impedance setting succeeded.
15. SET Δ INTERFACE
This command is used to specify the specifications of connection mode. Assign a correct setting corre-
sponding to connecting network equipment. To make this assignment effective, it is required to execute the
"SAVE" command and to restart before exiting the maintenance command.
MG-PRI(SIP)>SET INTERFACE
SPEED(AUTO/100M/10M):100M
DUPLEX(FULL/HALF):HALF
Ethernet Speed setting succeeded.
Δ P1
P1
P1-Specify a time (second) recognized as timeout in receiving
health check.
120-300=Available time.(Default: 150)
Result is displayed.
1) Select a line speed
AUTO=Auto Negotiation (default)
100M=100M
10M=10M
2) Select a type of duplex (not displayed when SPEED=AUTO)
FULL=Full duplex
HALF=Half duplex
Result is displayed.
VOL.2-1097
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
ON=FAX ECM is valid
OFF=FAX ECM is invalid (default)
Result is displayed.
P1-Specify the available time to switch to FAX.
0=FAX switching is unavailable.
1-5=Available time to be switched to FAX (minutes)
OFF=Always-on FAX switching
Result is displayed.