NEC Univerge sv8500 Manual page 1365

Host Name: SVR1.nec.com
SIP server setting succeeded.
About IP address of SIP server (Telephony Server), refer to "Registration Destination of IP Devices/Sta-
Note 1:
tions" in INTRODUCTION of Installation Manual.
30. SET Δ SMOOTH_PAD
This command is used to specify Smooth PAD mode of DSP. To make this assignment effective, it is re-
quired to execute the "SAVE" command and to restart before exiting the maintenance command.
MG-PRI(SIP)>SET SMOOTH_PAD 2
Smooth PAD Mode setting succeeded.
31. SET Δ STARTPORT
This command is used to specify the starting port of RTP. Enter an even number for the RTP. The odd num-
ber (the even number +1) is assigned for RTCP. To make this assignment effective, it is required to execute
the "SAVE" command and to restart before exiting the maintenance command.
MG-PRI(SIP)>SET STARTPORT 1024
RTP Start Port Number setting succeeded.
32. SET Δ TCP_TIMER
This command is used to specify the timer waiting for TCP link connection.
MG-PRI(SIP)>SET TCP_TIMER 60
TCP Link Connect Timer Timeout setting succeeded.
33. SET Δ VLAN
This command is used to specify the settings for VLAN. To make this assignment effective, it is required
to execute the "SAVE" command and to restart before exiting the maintenance command. In MG, one
VLAN can be created per network.
MG-PRI(SIP)>SET VLAN
Please enter a parameter
Δ P1
Δ P1
Δ P1
VOL.2-1112
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
Specify the host name by fully domain name. A charac-
ters can be specified up to 63 bytes (including hyphen
and full stop).
Result is displayed.
P1-Specify a value of Smooth PAD mode.
OFF=Set Smooth PAD to OFF
1=+2dBm (Default)
2=-5dBm
3=-2dBm
4=0dBm
5=-4dBm
Result is displayed.
P1-Specify the port number to start RTP
1024-64510= Port Number (Default: 1024)
Result is displayed.
P1-Specify the waiting time (30 sec-
onds interval)
60-80 =effective waiting time (De-
fault: 60)
Result is displayed.