To reflect the configuration data that is downloaded from TFTP server, save it by entering
STEP 12
"save config" and reboot MG(PRI) by entering "reboot".
Exit the HyperTerminal by selecting [File] -> [Exit].
STEP 13
<Confirmation of MG(PRI)>
Connect the MG(PRI) to the network.
STEP 14
Confirm that MG(PRI) is normally registered in system after reboot. Use the DISD/FPTS
STEP 15
commands in PCPro. For more information, refer to the Command Manual.
Check that calls via MG(PRI) can be made.
STEP 16
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
VOL.2-1067