NEC Univerge sv8500 Manual page 1023

SHOW: Command to display the configuration data
Sub-command
1 CONFIG
2 DHCP
3 DRS_IPADDRESS
4 EXTERNAL_MUSIC_LEVEL
5 FAX_DETECTION_TIME
6 HC_RCV_TIMER
7 INTERFACE
8 LAN_ERROR_CHECK
9 OWN_IPADDRESS
10 SIGNALING_PORT_NO
11 SIGNALING_QOS
12 SMOOTH_PAD
13 PRE-NEGOTIATION_PORT_NO
14 RTP_START_PORT_NO
15 VLAN
16 WARNING_TONE_CONTROL
The following commands are available for MG-BRI with the firmware version: SP-3709 BRI MG BSC
Note:
PROG-A Issue 18 or later.
Sub-command
1 CALL_HOLD
2 RTP_STOP_DETECT
Displays the list of current configuration data.
Displays the current setting of DHCP
Displays the IP Address and Port Number of DRS.
Displays the current setting of external hold tone settings.
Displays the current setting of effective switching time for FAX.
Displays the current setting of Time-out value for Telephony Server
health check packet waiting process.
Displays the current setting for speed and activation mode of Ethernet
controller.
Displays the interval to detect LAN cable fall-off.
Displays the IP Address, Subnet Mask and Default Gateway currently
assigned.
Displays the Signaling Port number currently assigned.
Displays the setting status for current Signaling Session.
Displays the current Smooth PAD mode.
Displays the current setting for Port number to be used for sending/
receiving H.245 Pre-negotiation Packet.
Displays the RTP start port number currently assigned.
Displays the current VLAN setting status.
Displays the current setting of warning tone when LAN failure.
Displays the current setting of MG Based Call Retention.
Displays the current setting of Receive Stop Detect timer.
VOL.2-770
Function
Function
MG-BRI