G-Cot Card [Sca-6Cotb] - NEC Univerge sv8500 Manual

10. MG-COT Card [SCA-6COTB]
10.1 General
10.1.1 What is MG-COT?
MG-COT has a function of Media Gateway (MG) which is an interface between IP network and Analog PSTN
line. Also an analog terminal for exclusive use of Power Failure Transfer (PFT) can be connected through a PFT
connector on this card.
MG usually works independently. In the case of failure of MG-COT, PFT connects C.O. line and analog termi-
nal directly and provides emergency line.
For the PFT service on the UG50, a station line connected to the PFT port cannot be used as a station line
Note:
for the system. Be sure to connect a terminal that can be used as telephone to the PFT port. Terminals such
as a FAX terminal are not allowed.
MG-COT Card is mounted on 1U-MPC (Multi Purpose Chassis) module. One unit of 1U-MPC module can
Note:
accommodate a maximum of two cards. MG-COT Card is mounted in the left slot in this figure.
Only MG0 can be used for PFT function. An analog terminal connected to the PFT connector cannot be
Note:
used when the MG-COT operates normally.
Note
Outerview of MG-COT
MG0 MG2 MG4 PFT
MG1 MG3 MG5
MG0 MG2 MG4
100M LINK
CONSOLE MUSIC
ON
PWR ALM LINE
MG1 MG3 MG5 RESET
Ether
OPERATION
MG-COT Card [SCA-6COTB]
VOL.2-614
MG6
MG-COT Card [SCA-6COTB]