NEC Univerge sv8500 Manual page 1338

14.4.6 SETUP Command
1. SETUP Δ SP
This command is used to set up network environment of MG(PRI) SIP mode.
MG-PRI(SIP)>SETUP SP
---DHCP Interface set---
Current DHCP Interface:ENABLE
Change DHCP Interface? [Y (change)/N (current)/Q
(quit)]: Y
Input new DHCP Interface [E (enable)/D (disable)]:D
--- DNS Interface set ---
Current DNS Interface: DISABLE
Change DNS Interface? [Y (change)/N (current)/
Q(quit)]: Y
--- DNS IP Address set ---
Current DNS IP Address: 0.0.0.0
Change DNS IP Address ? [Y(change)/N(current)/
Q(quit)]:y
Input new DNS IP Address: 10.40.1.150
--- IP Address & Subnetmask set ---
Current IP Address: 0.0.0.0
Current Subnetmask: 255.255.255.255
Change IP Address and Subnetmask? [Y (change)/N (cur-
rent)/Q(quit)]: Y
Input new IP Address: 10.41.1.100
Input new Subnet mask: 255.255.255.0
--- Host Name set ---
Current Host Name: No Value
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
VOL.2-1085
The current setting is displayed.
1) Select the DHCP setting.
Y: Change the setting
N: Remain the current setting
Q: Exit the command
2) Enable/Disable the DHCP
Server.
E: Enable a new DHCP Server
(default)
D: Disable DHCP Server
The current setting is displayed.
3) Select the DNS setting.
Y: Change the setting
N: Remain the current setting
Q: Exit the command
The current setting is displayed.
3) Select the DNS setting.
Y: Change the DNS IP Address.
N: Remain the DNS IP Address.
Q: Exit the command
The current setting is displayed.
6) Select the network setting of
MG(PRI).
Y: Change the setting
N: Remain the current setting
Q: Exit the command
7) Specify a new IP address.
8) Specify a new subnet mask.
The current setting is displayed.