NEC Univerge sv8500 Manual page 498

IP Precedence/DiffServ: Select either of the radio buttons.
<When IP Precedence is selected>
Precedence:
Low Delay:
Through Put:
Reliability:
MIN Cost:
<When DiffServ is selected>
DSCP:
Default settings (IP Precedence, Precedence=5, Low Delay=OFF, Throughput=OFF, Reliability=OFF,
Note:
Min Cost=OFF) is applied when the check box is not clicked.
Setting of Payload: Click the check box to assign the Payload data. Specify the Payload Type and Payload
Payload Type: Select one of the payload type in the combo box.
Payload Size:
•
If payload type G.711 is specified to more than two priorities in PRI1 through PRI4, assign different
Note:
payload size to each priority.
When payload types G.723.1 (5.3K → 6.3K) and G.723.1 (6.3K → 5.3K) are to be assigned on the same
•
terminal, specify the same value to the payload size of both types.
• It is not necessary to assign the payload type/size to the whole priorities. Specifying the first priority
only is allowed.
• For available payload type/payload size, refer to Peripheral Equipment Description, Volume 1, Chap-
ter 2, "3.1.1 Bandwidth Required for Voice Traffic."
Setting of PAD: Click the check box to assign the PAD data manually. If not checked, default value 0 is
KIND2: Specify the PAD value of Analog MC in the range of 0-3.
KIND3: Specify the PAD No. of IPPAD in the range of 0-15.
Specify the precedence in the range of 0-7 (low-high).
Place a checkmark to set Low Delay to ON.
Place a checkmark to set High Throughput to ON.
Place a checkmark to set High Reliability to ON.
Place a checkmark to set Cost Precedence to ON.
Specify the DiffServ Code Point in the range of 0-63.
Size in the order of priority 1 to 4 (PRI1 through PRI4).
•No data
•G.711
•G.729.a
•G.723.1 (5.3K →
•G.723.1 (6.3K →
Select one of the payload size in the combo box according to the Payload Type.
•No data
•10 milliseconds
•20 milliseconds
•30 milliseconds
•40 milliseconds
•60 milliseconds
applied.
•No PAD control (determined by ASYD, SYS1, INDEX 4, bit5 (5 dB PAD))
•PAD OFF (0 dB)
•3 dB
•6 dB
PAD value is determined by this PAD No. (0-15) and the setting of SW10-6/7 on IPPAD
card. Refer to the Circuit Card Description for more details.
6.3K)
5.3K)
VOL.2-245
MC & MG with PFT