NEC Univerge sv8500 Manual page 1029

12. SET SMOOTH_PAD
Assign the Smooth PAD
MG-BRI>set smooth_pad P1
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
13. SET PRE-NEGOTIATION_PORT_NO
H.245 Pre-negotiation Packet.
Assign the Port number to be used for sending/receiving H.245 Pre-negotiation Packet.
MG-BRI>set pre-negotiation_port_no P1
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
14. SET RTP_START_PORT_NO
Assign the Start number of Port to be used in RTP.
MG-BRI>set rtp_start_port_no P1
Specify even number for port number (The port number of RTCP port will be automatically assigned to
Note:
[Number specified + 1 (odd number)])
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
15. SET VLAN: Assignment of VLAN.
Assign the Tag VLAN information.
MG-BRI>set vlan
VLAN_ID(1-4094):1
COS(0-7):6
IP Address:10.41.1.200
Subnet mask:255.255.255.0
There will be no VLAN assignment when "0" was assigned for VLAN ID.
Note:
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
:
Assignment of the Smooth PAD
:
Assignment of Port number to be used for sending/receiving
:
Setting of RTP start port
VOL.2-776
P1: Specify the mode (Default: 1)
0: Do not use the DSP Smooth PAD
1: -8.2 dBm (Default)
2: -5.2 dBm
3: -2.1 dBm
4: -6.4 dBm
5: -4.2 dBm
P1: Port Number (Default: 10001)
P1: Port Number (1024-6552)
(Default: 1024)
Assign VLAN ID (1-4094)
Assign setting value of CoS (0-7)
Assign IP Address of VLAN
Assign Subnet Mask of VLAN
MG-BRI