NEC Univerge sv8500 Manual page 1019

11.7.4 Operation of Configuration Command
Configuration command is used just for modifying the default data. Data is to be modified only when it is
required and to the necessary part.
"DRS (Device Registration Server)" used in this section refers to the Telephony Server. The Telephony
Note:
Server acts as DRS for MG-BRI using Proprietary Protocol.
When an event causing a restart of the device, such as health check timeout, occurs during startup of the
Note:
configuration command, it takes about five minutes to start the rebooting after you exit from the configu-
ration command or enter the last command.
By using the communication software such as HyperTerminal (
the power or pressing the reset switch.
When boot program has started, configuration command menu shown below appears by pressing the
"ESC" key while "Starting MG-BRI boot program" is displayed. Enter "1" and press the "RETURN" key.
-<Boot mode>Main menu-
Configuration data. --- input:1
Quit ------------------ [Q/q]
Input:1
Display change as follows. enter the command into this prompt to modify the configuration data.
<Configuration data setting mode>
MG-BRI > ＿
Assign the communication setting of External Maintenance Terminal (PC) as follows.
Note 1:
Bits per second
Data bits
Parity
Stop bits
Flow control
11.7.5 Basic Command Entry
Displays the prompt of command interface, then displays the Reply message by analyzing the character
entered by the user. Command and Sub-command is mandatory, but Parameter vary depends on each Com-
mand. Example of Command, Sub-command and Parameter is shown below.
Prompt Command
MG-BRI> set
9600 bps
8 bits
No
1 bit
No
Sub-command Parameter 1 (P1)
own_ipaddress 123.201.18.45
VOL.2-766
), start a boot program by turning on
Note 1
Parameter 2 (P2)
255.255.255.0
MG-BRI