NEC Univerge sv8500 Manual page 1326

Set network environment for the TFTP server.
STEP 5
IP Address: 10.41.1.250
Subnet mask: 255.255.255.0
Start the TFTP program.
STEP 6
Power on MG(PRI).
STEP 7
Activate HyperTerminal and set the following:
STEP 8
Bit per second:9600bps
Data bits:8bit
Parity:None
Stop bit:1bit
Flow control:None
After a prompt (">MG-PRI" or ">MG-PRI(SIP)") is displayed, enter "download".
STEP 9
When "Do you need download?" message is displayed, enter "y".
STEP 10
The current settings of MG(PRI) are displayed, and then the screen asks you to input TFTP
STEP 11
Server IP Address. Enter a TFTP server IP address.
The current settings of MG(PRI) and TFTP server are displayed. Make sure of the settings.
STEP 12
If you need to modify the settings, select a number (1-4) to modify the item. If all the settings
are correct, enter "y".
Download menu is displayed, and then select "1" (Download of all programs).
STEP 13
IP address information setting is displayed, and then select "1" (current setting).
STEP 14
Other configuration setting is displayed, and then select "2" (current setting).
STEP 15
After download process is completed, MG(PRI) will reboot.
Turn off and on the power of the MG(PRI).
STEP 16
After a prompt (->) is displayed, enter "dispver" to display the firmware information of
STEP 17
MG(PRI).
After a prompt (->) is displayed again, enter "usrConsole".
STEP 18
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
VOL.2-1073