NEC Univerge sv8500 Manual page 433

26. Setting QoS for SIP signaling session:
• When TOS is selected in QoS setting type:
MC(SIP)> SET SIGNALING_QOS
QOS (TOS/DIFFSERV) [TOS]: TOS
PRECEDENCE (0-7) [6]: 6
DELAY (0/1) [0]: 0
THROUGHPUT (0/1) [0]: 0
RELIABILITY (0/1) [0]: 0
COST (0/1) [0]: 0
Signaling QoS setting succeeded. (0xC0)
The result of data setting is shown in a 1-byte (hexadecimal) format in accordance with the setting dialog
Note:
followed by the prompt. The meaning of 1-byte data is shown below:
Prec.
• When DIFFSERV is selected in QoS setting type:
MC(SIP)> SET SIGNALING_QOS
QOS (TOS/DIFFSERV) [TOS]: DIFFSERV
DSCP (0-63) [48]: 48
Signaling QoS setting succeeded. (0xC0)
The result of data setting is shown in a 1-byte (hexadecimal) format in accordance with the setting dialog
Note:
followed by the prompt. The meaning of 1-byte data is shown below:
DSCP
The value in [ ] shows the current setting. Press enter key to apply the current setting shown in [ ].
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
8LC Card [SCA-8LCA/SCA-8LCA-EMEA/SCA-8LCC/SCA-8LCC-EMEA]
D T R C
Select QoS setting type [TOS/DIFFSERV]
(default=TOS)
Precedence: 0-7 (low-high) (default=6)
Delay: 0/1=Normal (default)/Low Delay ON
Throughput: 0/1=Normal (default)/High Throughput ON
Reliability: 0/1=Normal (default)/High Reliability ON
Cost: 0/1=Normal (default)/Cost Precedence ON
Result is shown.
Prec.=PRECEDENCE (3 bits)
D=Delay
T=Throughput
R=Reliability
C=Cost
Select QoS setting type [TOS/DIFFSERV]
(default=TOS)
Enter the setting value directly [0-63] (default=48)
Result is shown.
DSCP = Differentiated Service Code Point (6 bits)
VOL.2-180