NEC Univerge sv8500 Manual page 1108

<Custom Mode Command List>
SET: Command to assign the configuration data
Sub-command
1 DEFAULT_GATEWAY
2 DHCP_SV
3 DNS_IPADDRSS
4 DNS_SV
5 FAX_DETECTION_TIME
6 HC_RCV_TIMER
7 INTERFACE
8 LAN_ERROR_CHECK
9 ONE_TIME_PASS
10 OWN_IPADDRESS
11 RTP_START_PORT_NO
12 SIGNALING_PORT_NO
13 SIGNALING_QOS
14 SIPSV_IPADDRESS
15 SMOOTH_PAD
16 VALUE
17 VLAN
18 WARNING_TONE_CONTROL
SHOW: Command to display the configuration data
Sub-command
1 CONFIG
2 DEFAULT_GATEWAY
3 DHCP_SV
4 DNS_IPADDRESS
5 DNS_SV
Assign the IP address of Default Gateway.
Assign whether to use DHCP Server or not.
Assign the IP Address of DNS server.
Assign whether to use DNS server or not.
Assign the effective switching timer for FAX
Assign the Time-out value for Telephony Server health check wait-
ing process.
Assign the speed and activation mode of Ether controller.
Assign the interval to detect LAN cable fall-off
Assign the one time password to be used for the first registration af-
ter connected to network.
Assignment of IP Address, Subnet Mask, and Host Name of
MG(BRI) itself.
Specify the first port number to be used for RTP.
Assign the port number to be used for PHI signaling.
Assign the ToS value added to signaling (SIP server signaling) ses-
sion.
Assign the IP address, port number, and host name of SIP server.
Assign the Smooth PAD
Assign the VALUE
Assign the Tag VLAN information.
Assign whether to use warning tone when LAN failure or not.
Displays the list of current configuration data.
Displays the current setting of Default Gateway.
Displays the current setting of DHCP server.
Displays the current IP address setting of DNS server.
Displays the current setting of DNS server.
VOL.2-855
MG(BRI) [SCA-2BRIA/MG-2BRIA]
Function
Function