NEC Univerge sv8500 Manual page 1015

Enter "cmd" for Input
STEP 11
Enter "ipxadmin" for password.
STEP 12
After a prompt (>>>Set command :) is displayed, enter "download".
STEP 13
The File Download mode is displayed. Input "2" (Download of one program).
STEP 14
If you input "1" (Download of all programs), system data of the terminals such as IP address, will be over-
Note:
written by initial data.
Input "n" (set the existing IP address) for MG-BRI's IP address set.
STEP 15
Input "n" (set the existing IP address) for TFTP's IP address set.
STEP 16
Make sure correct IP addresses are set in TFTP server and MG-BRI. And then input "y" if
STEP 17
they are correct.
The Program download menu is displayed. Input "0" to download BSC program.
STEP 18
BSC program is downloaded and written into Flash ROM.
After all the download is completed, enter "q" to reboot the system.
STEP 19
Activate HyperTerminal and connect to MG-BRI.
STEP 20
If you want to confirm the version information, enter "show version".
Connect the MG-BRI to a network.
STEP 21
To confirm MG-BRI is operating properly with the upgraded firmware, make a call to the
STEP 22
MG-BRI. Check that you can hear RBT.
Receive a call via the MG-BRI, and confirm that you are able to talk to each other.
STEP 23
After all the tasks are completed, write down or label the firmware version installed in the
STEP 24
MG-BRI onto the back of it.
VOL.2-762
MG-BRI