NEC Univerge sv8500 Manual page 915

• When DHCP server is used
As DHCP server automatically assigns IP addresses to MG-COT Card, Default Gateway, and the Telepho-
ny Server, there is no need to assign these network data on MG-COT Card side. IP addresses listed below,
however, have to be prepared in DHCP server side.
• IP address of Default Gateway
• IP address and port number of DRS
* Check the number of IP address saved in DHCP server is sufficient so as to get IP address of MG-COT
Card anytime.
DHCP option setting is as follows.
Note 1:
Class: Global
Name: Not specified, but do not enter the same option name in duplicate
Data: IP address
Array: Checked
Code: 161
Refer to DHCP Server in Volume 1 of this manual for more information on DHCP option setting.
About IP address of DRS, refer to Vol.1, Chapter 2, "2. IP Related Basic Programming" in this manual.
Note 2:
MG-COT> setup tp
MG-ID = xx:xx:xx:xx:xx:xx
Use DHCP?
Input (Y:Yes/N:No/Q:Quit):y
--------------------------------------
MG-ID = xx:xx:xx:xx:xx:xx
DHCP = ENABLE
--------------------------------------
Input (Y:OK / N:Change / Q:Quit):y
If DHCP server is set for use, DHCP Option will be set for use automatically. If you do not assign the IP
Note:
address of DRS to DHCP server, It must be assigned by "SET DRSADDRESS" command individually.
Write down the displayed MG-ID (MAC address of MG-COT Card) to assign the MAC address on PCPro
Note:
command AMGIL and AISTL.
Note 1
Note 2
Input "setup tp" and press Enter key.
MG-COT Card's MAC address is displayed.
Set whether to use DHCP server.
Input "y" here and press Enter key.
Confirm the assigned data. Input "y" and press Enter key.
The assigned data is automatically saved and start re-
booting. The data turns effective after rebooting the MG-
COT Card.
VOL.2-662
MG-COT Card [SCA-6COTB]