Assign the Trunk Data to Virtual Signaling Channel, referring to page 1041.
STEP 11:MBTK (Make Busy of Trunk)
Cancel the Make-Busy of Virtual Speech Path.
RT:
Route Number
TK:
Trunk Number
MB:
0(Make-Busy Cancel)
STEP 12:AMGIL (Assignment of Media Gateway Information for LDM)
Make sure to assign in order of ATRK
Note:
Assign MG(PRI).
MG-ID:
MAC Address of MG(PRI) (6 byte of HEX data)
* MAC address is labeled on the left front of MG(PRI) (below PWR lamp).
FUNCTION:Setting (to assign MG information)
KIND:
ISDN Trunk (PRI 1.5M) [SIP]
LINE:
0 (fixed)
CH:
0 (fixed)
LENS:
Accommodating Location of Virtual Speech Channel.
Assign the first channel of HW to which Virtual Speech/Signal Channel is allocated.
* Make sure that LENS number assigned here already has been assigned by the ATRK.
RETRY:
Number of retry to request connection to MG(PRI).
SERVICE TYPE:QoS settings of signal path (ToS value applied when MG(PRI) connects to Internal PHI-
PRI)
STEP 13:AMGVL (Assignment of Media Gateway Voice Control Data for LDM)
Assign the Voice control data to connect to MG(PRI).
A RT (Storing MG): Route number of virtual speech channel used for MG(PRI).
TYPE:
B RT (MG Storing): Displayed when TYPE=Route Specified is selected.
B LOC-ID:
Setting of Jitter Buffer:JB_MIN [0-30 (
Setting Type of Voice Packet Service: IP PRECEDENCE [0-7]/DIFFSERV [00-63]
Setting of Payload: TYPE, SIZE
For using this parameter, refer to Peripheral Equipment Description, Volume 1, Chapter 2, "3.1.1 Band-
Note 1:
width Required for Voice Traffic."
[4] Security Data Assignment
Assign authentication data for SIP Mode.
→
AMGIL.
Select "Route Specified" or "Location ID Specified".
Used when connecting MG and MG in Tandem. Assign the route number of virtual
speech channel for the destination MG.
Displayed when TYPE=Location ID Specified is selected.
Assign the location ID where the destination IP station belongs. (Preferred)
×
10 milliseconds)], JB_MAX [0-30 (
Note 1
VOL.2-1043
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
×
10 milliseconds)]